golana

Well, I went to Pick N Pull on Sunday, and found some awesome full-power (power windows, power mirrors, power locks) out of a (you guessed it) Blazer! These doors were the best condition doors I could find that had full power, so I had to go with them.


Sittin in the room, after a good scrub down at work to get the mud off (it was a freaking mud pit there on Sunday!)


Yay for power mirrors!


This is a really cool symbol, too bad I cant use it on anything... Might throw it on my tool box.


Only a slight problem hahaa, these doors were from a 4 door Blazer, and my truck is only 2 door. So I have 2 extra window switches on the switch panel hahaa! might try to figure out something cool with the side windows, or I might just grab a 2 door switch panel...


Wire Harness. What a mess hahaa! Actually, its not too bad. Ive got it all figured out now, I just need a power mirror switch now.


I ended up pulling the harness out because I needed to be sure about the power locks, also I had an 'extra' wire hanging out hahaa, it wasnt so extra after all... turned out that one of the wires snapped off, and the one I grabbed looked close enough to fool my eyes into thinking it was for the power mirrors, when in fact, it was the door lock solenoid wire hahaa! grey and dirty tan look close in crap lighting


So I fixed the craked wires and rebuilt the harness. It wasnt too bad, minus the crap glue stuff off that crappy tape GM uses... I hate that stuff :P


Another shot of the rebuilt harness.

So yea, on to the wiring this is what Ive got figured out!


Legend: DS = Driver Side
PS = Passenger Side
DS: A = Driver Side: Plug A on PED

Power Windows

DS Switch
DS Rear Motor
DS: A - Purple
DS: B - Dark Green
PS Rear Motor
DS: C - Purple White Stripe
DS: D - Light Green
Power/Ground
DS: E - Black - Ground
DS: F - Pink - +12v
DS Front Motor
DS: G - Brown
DS: H - Dark Blue
PS Front Motor
DS: J - Tan
DS: K - Dark Blue White Stripe

PS Switch
PS: A - Pink - +12v
PS: B = DS: J - Tan
PS Front Motor
PS: C - Dark Blue
PS: D - Brown
PS: E = DS: K - Dark Blue White Stripe

DS Motor
DS: A = DS: H - Dark Blue
DS: B = DS: G - Brown

PS Motor
PS: A = PS: D - Brown
PS: B = PS: C - Dark Blue

Power Locks

DS Lock Switch
DS: A - Orange Black
DS: B - Not Used
DS: C - Black - Ground
DS: D - Lt Blue
DS: E - Not Used

DS Lock Solenoid
DS: A - Tan
DS: B - Grey

PS Lock Switch
PS: A - Orange Black
PS: B - Not Used
PS: C - Black - Ground
PS: D - Lt Blue
PS: E - Not Used

PS Lock Solenoid
PS: A - Tan
PS: B - Grey


I had to modify my cluster surround so I could install the power window switch in the stock location.


before


Hole mocked up.

__________________

1992 Chevy S10 - Ext Cab - 4.3L 5spd - RWD
Shortram Intake, 2.5" Custom Exhaust, Bagged Front, 3" Dropped Rear, Shaved Doors

golana

After. Used my dremel tool to cut along the lines. ill clean up the cut when i repaint everything. i wasnt too worried, as the switch hides it anyways.


Switch mocked up.


Switch installed


before


after


Driver's side!


Doors on!

__________________

1992 Chevy S10 - Ext Cab - 4.3L 5spd - RWD
Shortram Intake, 2.5" Custom Exhaust, Bagged Front, 3" Dropped Rear, Shaved Doors